Remove the inlet fitting with split flange
Remove the setting screw,
Remove the plug,
Put the setting screw where the plug was,
Put the plug where the setting screw was,
Put seal on the inlet fitting, then the inlet fitting on the side
where the plug is, and fix with the split flange,
Tighten with the screws.
We added Special Mounting Flanges for G2SE Pumps.
SAE B 4 Bolt (SAE J744) Mounting Flange
SAE B 2 Bolt (SAE J744) Mounting Flange
SAE B 6 Bolt Special Mounting Flange for all G2SE Pumps.
We added Special Shaft Drive for G2M Motors.
- Splined Shaft 35xf7x2x9g GOST 6033-80
-
Splined Shaft 35xfx2x9g GOST 6033
- Special Parallel Keyed Shafts
-
1 3/8" 21T 16/32DP ANSI B92
-
1 1/2" 23T 16/32DP ANSI B92
-
Splined Shaft 40xf7x2x9g GOST 6033
- Splined Shaft 45xh8x2x9g GOST 6033-80
- A12x8x63 DIN 6885
- A14x9x63 DIN 6885
- A10x5x50 DIN 6885